Installation Manual

Configuration
April 24 2015 – Revision 1.0
Page 36 of 76
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
Service (Shift) button Use the Service button to access upper-case
letters or to initiate a service call to 3M or as
a confirmation in some items.
Pressing and holding the Service button while
editing a field that permits alphabet letter
entry (e.g., store address) shifts the letter to
upper case.
In run mode, press and hold the Service
button, then enter your passcode to initiate an
internet request for help from 3M. A 3M
representative will call your store telephone
number shortly after you initiate the request.
Your base station must be connected to the
internet for this function to work. If you
press the Service button and do not enter a
passcode, the base station will go to a
Service screen used for installation and
troubleshooting.
Lane button Use the Lane button to switch between Lane1
and Lane2. The Display Screen will switch
appropriately and display only those
configuration settings that are available for
that Lane. This applies to the Run Screen and
all Menu screens.
Using this switch while on the Service
Screen will have no effect on the displayed
content.
The directional arrows can be used for scrolling from one menu item to another
or to scroll through available choices when editing fields.
Configuring with a Computer
All of the procedures in this chapter assume that you are using the display to
configure your base station(s). However, the base station can function as a web
server, which means it can be configured using a PC. The web-server
functionality is disabled on a new base station, so it must be enabled and
configured on site.
To set up web-server functionality:
• Connect the base station:
• Peer-to-Peer – a direct connection between the base station and
the PC using a crossover cable
• Private network – a connection between the base station and a
router, switch or hub using an Ethernet cable. The PC is
somewhere on the same network.
• Enter the configuration mode, see page 34.
• Select 16 Network Setup .