Installation Manual

Configuration
3M™ Drive-Thru Systems G5 Basestation Model G5B1
Installation Manual
April 24 2015 – Revision 1.0
Page 51 of 76
Holiday/Exception Schedule
The holiday/exception schedule can be used to identify up to 12 days in the year
on which the store schedule is different than it would have been otherwise. The
holiday/exception schedule should be updated at least once a year to ensure it
conforms to the current year’s calendar.
Perform the following procedure to set the holiday/exception schedule:
• Enter the base station configuration mode, see page 34.
• Navigate to 10 Site Scheduling .> Holiday/Exception
Schedule .
• For each day that needs a non-typical schedule, enter the three-letter
month and two digit date under Date, then change the open and close
times on the line to the right of the date.
(Press , , ⊳, and  to scroll through the fields.)
Change Site Information
Site information is useful for warranty registration and to support service calls.
This information is most useful when the system has an internet connection.
Tech Services can use it to identify and contact the store when it receives a
service request. All information is entered free-format using the numeric
keypad. To type upper case letters, use the Shift key.
Perform the following procedure to change the site information:
• Enter the base station configuration mode, see page 34.
• Navigate to 11 Site Information .
• For each field that needs to be modified, enter the appropriate data.
(Press , , ⊳, and  to scroll through the fields.)
Digital IO Setup
The Digital IO Setup allows you to configure the 16 logical General Purpose
Input and Output ports. All Inputs and Outputs are Active Low. You can
reassign any of these GPIO ports to either, provide a signal (OUT) or accept a
signal (IN).
You can assign what action the basestation needs to take upon receiving a signal
(IN) on one of these ports. The choices are:
- SPLIT/CROSS – change Lane Modes
- ORDER TAKING – toggle through enabled Order Taking Modes
- DAY/NIGHT – change Volume Mode
- EXT_MSG – Playback assigned message anytime external detector is
activated
- VEH_APP_1 – Monitor vehicle approach on Lane1
- VEH_APP_2 – Monitor vehicle approach on Lane2
- Any Alert messages recorded in the system.