User's Manual

Configuration
September 2012 – Revision 1.9 DRAFT
Page 40 of 66
3M™ Wireless Communication System Model XT-1
Installation Manual
On the base first station:
• E
nter the base station configuration mode, see page 30.
• Change the value for 07 Global Settings > Number of
BaseStations at This Site to 2.
• Press Enter to implement the change.
• On the first base station, stations, change the value for 07 Global
Settings > Lane Number of This Base Station to 1.
On the second base station:
• Enter the base station configuration mode, see page 30.
• Change the value for 07 Global Settings > Number of Base
Stations at This Site to 2.
• Press Enter to implement the change.
• On the second base station, stations, change the value for 07 Global
Settings > Lane Number of This Base Station to 2.
Store is Now Closed Prompt
Perform the following procedure to enable or disable the automatic store closed
prompt to let customers know in your absence that the store is closed:
Note:
Make sure that you disable the automatic store closed prompt in stores that are
open 24 hours.
I. Enter the base station configuration mode, see page 30.
• Change the value for 07 Global Settings > ”Store is Now
Closed” Prompt? to Yes or No.
Pull Ahead Prompt
You can let customers know to pull ahead when they are at order point #2 in a
tandem drive thru when it is out-of-service.
Figure 19
Perform the following procedure on Base #2 to enable or disable the automatic
p
ull ahead for Order Point #2:
• Enter the base station user service mode, see page 30.
• Change the value for 07 Global Settings > ”Pull Ahead”
Prompt (Tandem Only)? to Yes or No.
Pick Up
Cash
Order
Point #2
Order
Point
#1