User's Manual
Table Of Contents
- Introduction and Basics
- Introduction
- Safety Information
- Installing and Moving Sprite
- Safety
- External Machine Diagram
- Machine Specifications
- Contact Information
- Basic Operation
- Sample Placement
- Contact Information
- Components
- Main Screen
- Begin a New Scan Screen
- Scanning Screen
- Scan Review Screen
- Processing Setup Screen
- Results Screen
- _
- Locate a Scan Screen
- Background Processing Screen
- Utilities Screen
- System Sleep Button
- Touch screen Calibration Button
- System Shutdown Button
- Storage Device Management Button
- Network Configuration Button
- One Touch Scan Setup Button
- Submit Trouble Ticket Button
- Reset Processing Engine Button
- Reset System Board Service Button
- Reset X-ray Service Button
- Reset Scan Engine Button
- System Restart Button
- System Status Screen
- X-ray System Maintenance Screen
- Common Elements
- Technical Support
Components
17
Background Processing Button
The Background Processing button provides access to the Background Processing screen. This
button appears on the main screen and in the bottom right corner of every screen.
If the gears of this button are moving, image processing (or reconstruction) is under way.
Note: You may not begin a scan while any image processing is under way.
X-ray System Maintenance Button
Tap this button to access the maintenance procedures to regularly perform on Sprite.
These procedures – conditioning and detector calibration – are required for the X-ray source and
detector to perform at their highest levels.
When you tap this button the X-ray System Maintenance screen appears.
Begin X-ray Conditioning
If the X-rays have not been conditioned within the required time frame, a message reading "Begin
X-ray Conditioning" will appear below the X-ray System Maintenance button. (In addition, a
message readying "X-rays Need Conditioning" appears below the Begin a New Scan and One
Touch Scan buttons.) If you receive this message, you must condition the X-rays before
scanning.
Tap the X-ray System Maintenance button to begin X-ray conditioning. The conditioning begins
automatically, and the X-ray System Maintenance screen appears.