User's Manual
Table Of Contents
- Introduction and Basics
- Introduction
- Safety Information
- Installing and Moving Sprite
- Safety
- External Machine Diagram
- Machine Specifications
- Contact Information
- Basic Operation
- Sample Placement
- Contact Information
- Components
- Main Screen
- Begin a New Scan Screen
- Scanning Screen
- Scan Review Screen
- Processing Setup Screen
- Results Screen
- _
- Locate a Scan Screen
- Background Processing Screen
- Utilities Screen
- System Sleep Button
- Touch screen Calibration Button
- System Shutdown Button
- Storage Device Management Button
- Network Configuration Button
- One Touch Scan Setup Button
- Submit Trouble Ticket Button
- Reset Processing Engine Button
- Reset System Board Service Button
- Reset X-ray Service Button
- Reset Scan Engine Button
- System Restart Button
- System Status Screen
- X-ray System Maintenance Screen
- Common Elements
- Technical Support
Components
19
Begin a New Scan Screen
The Begin a New Scan screen appears when you tap Begin a New Scan on the main screen.
Use this screen to choose the settings (or parameters) for a full imaging scan, a system
calibration or validation.
Note: The screen capture below applies to a full imaging scan. The screen is configured slightly
differently for system calibrations and validations. Sprite determines by what you place on the
stage whether you are performing a full imaging scan, a system calibration or a validation.
To start the actual scan, fill out the scan settings (Scan Name, Resolution, etc.), and then tap the
Scan button. The scanning begins, and you are taken to the Scanning screen.
This is a reproduction of the Begin a New Scan screen. The components of this screen are
described below.
Image Area
Any preview images produced prior to scanning are displayed on the screen. You may want to
adjust the sample's placement or the scan settings after seeing the preliminary image.