User's Manual
Table Of Contents
- Introduction and Basics
- Introduction
- Safety Information
- Installing and Moving Sprite
- Safety
- External Machine Diagram
- Machine Specifications
- Contact Information
- Basic Operation
- Sample Placement
- Contact Information
- Components
- Main Screen
- Begin a New Scan Screen
- Scanning Screen
- Scan Review Screen
- Processing Setup Screen
- Results Screen
- _
- Locate a Scan Screen
- Background Processing Screen
- Utilities Screen
- System Sleep Button
- Touch screen Calibration Button
- System Shutdown Button
- Storage Device Management Button
- Network Configuration Button
- One Touch Scan Setup Button
- Submit Trouble Ticket Button
- Reset Processing Engine Button
- Reset System Board Service Button
- Reset X-ray Service Button
- Reset Scan Engine Button
- System Restart Button
- System Status Screen
- X-ray System Maintenance Screen
- Common Elements
- Technical Support
Components
27
Scan Review Screen
This screen allows you to view the status of the various scan types (i.e., reconstruction, system
calibration, or validation), to access the results of the scan, and to manipulate the scan's raw
images. When the scan is complete, you may tap the associated arrow in the table to see the full
results.
After your sample is scanned, the raw image is automatically processed to allow for further
reconstruction. This screen allows you to view the status of the various scan types (i.e.,
reconstruction, system calibration, or validation) as they process. You may also manipulate the
scan's raw images and access the Processing Setup screen to process a reconstruction or view
completed reconstructions.
You will know automatic processing is finished when three images appear in the table (these are
the top, front, and side views of your sample). To begin a reconstruction job, tap the Process
button. After entering the settings on the following screen, you will return to this screen while the
processing takes place. When the processing of the system calibration or validation report
processes or the reconstruction job is complete, you may tap the associated arrow in the table to
see the full results.
Note: You may perform unlimited reconstructions on any full imaging scan. All reconstructions of
a single image will appear on this screen in the scan/reconstruction table and may be accessed
through the Locate a Scan screen.
This is a reproduction of the Scan Review screen. The components of this screen are described
below.