User's Manual
Table Of Contents
- Introduction and Basics
- Introduction
- Safety Information
- Installing and Moving Sprite
- Safety
- External Machine Diagram
- Machine Specifications
- Contact Information
- Basic Operation
- Sample Placement
- Contact Information
- Components
- Main Screen
- Begin a New Scan Screen
- Scanning Screen
- Scan Review Screen
- Processing Setup Screen
- Results Screen
- _
- Locate a Scan Screen
- Background Processing Screen
- Utilities Screen
- System Sleep Button
- Touch screen Calibration Button
- System Shutdown Button
- Storage Device Management Button
- Network Configuration Button
- One Touch Scan Setup Button
- Submit Trouble Ticket Button
- Reset Processing Engine Button
- Reset System Board Service Button
- Reset X-ray Service Button
- Reset Scan Engine Button
- System Restart Button
- System Status Screen
- X-ray System Maintenance Screen
- Common Elements
- Technical Support
Sprite User's Manual
28
Image Area
The image area contains the raw images produced by the scan.
This is an image of an aluminum part.
This is an image of the calibration phantom.
Note: These images can be examined and manipulated while reconstruction occurs.
Action Button
The Action button represents actions that can be performed on the data. The button represents
verification for the user that the data can be processed into the next state.
Most likely this button will read "Process", which means that the system is ready to perform a
reconstruction. When you tap the Process button, you will be taken to the Processing Setup
screen to enter the reconstruction request.
Table Settings Button
The Table Settings button opens a dialog box that allows you to choose which columns are
displayed in the table on the Scan Review screen.
Select the check box next to the column headings you would like to see, and then tap Close to
enable your changes.