User's Manual
Table Of Contents
- Introduction and Basics
- Introduction
- Safety Information
- Installing and Moving Sprite
- Safety
- External Machine Diagram
- Machine Specifications
- Contact Information
- Basic Operation
- Sample Placement
- Contact Information
- Components
- Main Screen
- Begin a New Scan Screen
- Scanning Screen
- Scan Review Screen
- Processing Setup Screen
- Results Screen
- _
- Locate a Scan Screen
- Background Processing Screen
- Utilities Screen
- System Sleep Button
- Touch screen Calibration Button
- System Shutdown Button
- Storage Device Management Button
- Network Configuration Button
- One Touch Scan Setup Button
- Submit Trouble Ticket Button
- Reset Processing Engine Button
- Reset System Board Service Button
- Reset X-ray Service Button
- Reset Scan Engine Button
- System Restart Button
- System Status Screen
- X-ray System Maintenance Screen
- Common Elements
- Technical Support
Sprite User's Manual
32
Processing Setup Screen
The Processing Setup screen allows you to choose settings for in-depth reconstructions.
Among these settings is Region of Interest. With this setting you may designate a subvolume to
reconstruct.
To start the processing, fill out the reconstruction processing settings (set the region of interest,
update the description, select the data type and resolution, etc.), and then tap the Start
Processing button. The image processing begins, and you are taken to the Scan Review screen.
Note: You may not begin a scan while a reconstruction is processing.
This is a reproduction of the Processing Setup screen. The components of this screen are
described below.
Region of Interest
This screen displays three views (top, front, and side) of an image produced on the Scan Review
screen. From these images, you must choose a region of interest (or ROI) to perform intensive
reconstruction on.