User's Manual
Table Of Contents
- Introduction and Basics
- Introduction
- Safety Information
- Installing and Moving Sprite
- Safety
- External Machine Diagram
- Machine Specifications
- Contact Information
- Basic Operation
- Sample Placement
- Contact Information
- Components
- Main Screen
- Begin a New Scan Screen
- Scanning Screen
- Scan Review Screen
- Processing Setup Screen
- Results Screen
- _
- Locate a Scan Screen
- Background Processing Screen
- Utilities Screen
- System Sleep Button
- Touch screen Calibration Button
- System Shutdown Button
- Storage Device Management Button
- Network Configuration Button
- One Touch Scan Setup Button
- Submit Trouble Ticket Button
- Reset Processing Engine Button
- Reset System Board Service Button
- Reset X-ray Service Button
- Reset Scan Engine Button
- System Restart Button
- System Status Screen
- X-ray System Maintenance Screen
- Common Elements
- Technical Support
Components
45
If the touch screen is not responding as you would expect it to, tap the Touch screen Calibration
button. Calibration will begin automatically.
Follow the instructions on the touch screen to calibrate it.
First, touch the target as it moves around the screen.
Next, tap the screen and drag your finger. If the cursor follows your finger, tap the green check
box. If the cursor does not follow your finger, tap the retry button, and the calibration will run
again.
System Shutdown Button
To power off the entire Sprite system, tap the System Shutdown button.
Confirm or stop the shutdown in the confirmation window.
Note: If you shut down the system all the programs that are running will stop, and you may lose
data. Further, any scheduled automatic detector calibration and conditioning will be canceled.