User's Manual
Table Of Contents
- Introduction and Basics
- Introduction
- Safety Information
- Installing and Moving Sprite
- Safety
- External Machine Diagram
- Machine Specifications
- Contact Information
- Basic Operation
- Sample Placement
- Contact Information
- Components
- Main Screen
- Begin a New Scan Screen
- Scanning Screen
- Scan Review Screen
- Processing Setup Screen
- Results Screen
- _
- Locate a Scan Screen
- Background Processing Screen
- Utilities Screen
- System Sleep Button
- Touch screen Calibration Button
- System Shutdown Button
- Storage Device Management Button
- Network Configuration Button
- One Touch Scan Setup Button
- Submit Trouble Ticket Button
- Reset Processing Engine Button
- Reset System Board Service Button
- Reset X-ray Service Button
- Reset Scan Engine Button
- System Restart Button
- System Status Screen
- X-ray System Maintenance Screen
- Common Elements
- Technical Support
Sprite User's Manual
48
Search for Drives Button
Before you can store data on a drive, you must determine whether the drive can be used for data
storage. To do so, first plug the drive into a USB port. If you do not see the name of the drive
appear in the list of detected storage devices tap the Search For Drives button, and your drive will
appear in the list.
Detected Storage Devices
The default Sprite data drive is an external drive located in the cabinet, plugged into the internal
USB port. Devices listed under Detected Storage Devices have been detected in a USB port but
not yet tested and approved for data storage. To test and approve a drive, tap on the drive's
name and you will be asked to confirm your actions.
Sprite will run a performance test on the drive. If the drive is capable of storing scan information it
will appear in the Active Data Drives.
Network Configuration Button
Sprite is capable of networking with other computers and connecting with the internet. To take
advantage of this capability, you must have an available Ethernet outlet and an established local
area network (LAN). The Sprite installer configures your system for networking and internet
connectivity.
To access the network configuration settings, tap the Network Configuration button.
When you tap the Network Configuration button, the Network Configuration screen appears.
Network Configuration Screen
This screen displays and allows you to enter or change the information about your local area
network (if applicable).
This is a reproduction of the Network Configuration screen. The components of this screen are
described below.