User's Manual
Table Of Contents
- Introduction and Basics
- Introduction
- Safety Information
- Installing and Moving Sprite
- Safety
- External Machine Diagram
- Machine Specifications
- Contact Information
- Basic Operation
- Sample Placement
- Contact Information
- Components
- Main Screen
- Begin a New Scan Screen
- Scanning Screen
- Scan Review Screen
- Processing Setup Screen
- Results Screen
- _
- Locate a Scan Screen
- Background Processing Screen
- Utilities Screen
- System Sleep Button
- Touch screen Calibration Button
- System Shutdown Button
- Storage Device Management Button
- Network Configuration Button
- One Touch Scan Setup Button
- Submit Trouble Ticket Button
- Reset Processing Engine Button
- Reset System Board Service Button
- Reset X-ray Service Button
- Reset Scan Engine Button
- System Restart Button
- System Status Screen
- X-ray System Maintenance Screen
- Common Elements
- Technical Support
Components
55
System Status Screen
The System Status screen indicates the status of the hardware, mechanical, and software
systems and alerts you to any errors.
Sprite's various colored light bulbs and gauges serve as visual indicators of the overall system
status and the status of individual mechanical and software components. These indicators appear
not only on the System Status screen, but throughout the Sprite interface.
Note: This screen is primarily for diagnostics performed by IMTEC technical support. If you think
the system may have a problem or if you see a light that is any color besides green, you should
contact technical support.
This is a reproduction of the System Status screen. The components of this screen are described
below.
Gauges
These gauges are related to the electrical voltage detected for the X-ray source and other
mechanical components.
Test X-ray Lamp Switch
Tap the Test X-ray Lamp switch to test the "X-ray On" illuminating signs on either side of the
touch screen on front of the cabinet.