User's Manual
Table Of Contents
- Introduction and Basics
- Introduction
- Safety Information
- Installing and Moving Sprite
- Safety
- External Machine Diagram
- Machine Specifications
- Contact Information
- Basic Operation
- Sample Placement
- Contact Information
- Components
- Main Screen
- Begin a New Scan Screen
- Scanning Screen
- Scan Review Screen
- Processing Setup Screen
- Results Screen
- _
- Locate a Scan Screen
- Background Processing Screen
- Utilities Screen
- System Sleep Button
- Touch screen Calibration Button
- System Shutdown Button
- Storage Device Management Button
- Network Configuration Button
- One Touch Scan Setup Button
- Submit Trouble Ticket Button
- Reset Processing Engine Button
- Reset System Board Service Button
- Reset X-ray Service Button
- Reset Scan Engine Button
- System Restart Button
- System Status Screen
- X-ray System Maintenance Screen
- Common Elements
- Technical Support
Sprite User's Manual
60
To set your machine to automatically condition the X-rays and calibrate the detector on a
schedule, tap the Scheduled Maintenance button.
The switchboard and clock appear.
You may set the time that you would like automatic conditioning and calibration to begin by
tapping the plus and minus buttons next to the clock.
Choose the days you would like each procedure to run by tapping the switch for the
corresponding days. The switch is on when a green circle illuminates on it.
When you are finished, you may leave the switchboard on the screen or tap the Scheduled
Maintenance button to close it.
Note: When automatic conditioning and calibration begin, X-rays turn on and become active.