User's Manual

18 75-0500-4450-4 C, 060-A
When a confirmation for an action is
required, a button will be displayed
on the right side of the message
area. The example to the right
shows a case where the edge
sensors are covered and a
confirmation is required for the
SECURE action. The Check-in
button is the default action so the
user can press the Enter key on the
keyboard to select it, or touch the
Check-in button on the screen.
4 Place the Item on the Deck.
§ Place the book or other item on the
deck in the correct position for
processing (Figure 7). See
Placement of Items on the Deck
– General Guidelines.
Figure 7: Correct Position For Processing
The system checks for a digital identification tag or bar code.
§ If a digital identification tag is present, the workstation reads the tag.
§ If a digital identification tag is not present, the workstation goes into scan mode, which means the bar
code scanner will be turned on after a short delay and the workstation reads the bar code.
5 You will hear a sound.
The workstation emits several distinctive sounds:
§ a Thump Sound produced when two adjacent non-edge sensors are
covered and an item is secured/un-secured.
§ a Beep Sound produced if the security strip in the item was not
secured or un-secured (for example, for a video).
§ an Error Sound or Warning Sound to indicate that error or warning
conditions are detected.
6 Remove the item and place the next item on the deck for processing.
§ After you hear the thump sound or beep sound, remove the item and
place the next item on the deck. If an error/warning sound occurs,
follow the on-screen instructions.
7 To continue processing items, repeat Steps 4 - 6 above.
4