User's Manual

75-0500-4450-4 C, 060-A 19
Local and Remote Configurations
Use the following procedure to process items using the Digital Staff
Workstation - Local and Remote configurations.
Check-in/Check-out
The check-in and check-out functions send
IDs to the circulation system and secure, or
un-secure the item. Check-in (a) and check-
out (b) may be selected using the buttons to
the right, or through the Operation menu.
If you configured the Administrative
Settings to not allow choices (e.g.,
Check-in only or Check-out only),
only one of these buttons will appear.
1 Select the operation. The primary
operations are check-in and check-out.
§ Select the Check-In (a) or Check-Out (b)
button.
You can use hotkeys to select the
check-in and check-out buttons.
Hotkeys have been assigned in the
Companion software adminstrative
settings. Refer to the Digital Staff
Workstation Adminstrator's Guide for
further information on hotkeys.
2 Select the number of items to process in
the Items menu (if enabled)
3 Follow the Instructions.
Instructions appear in the Message area,
such as “Present Items.”
When a confirmation for an action is
required, a button will be displayed on
the right side of the message area. The
example to the right shows a case
where the edge sensors are covered
and a confirmation is required for the
SECURE action. The Check-in button
is the default action so the user can
press the Enter key on the keyboard to
select it, or select the Check-in button
on the screen.
Continued on next page…
Check-in and Check-out buttons
Companion UI Staff screen - Item menu
Check-in message in the Companion UI screen.
b
a