User's Manual

20 75-0500-4450-4 C, 060-A
4 Place the Item on the Deck.
§ Place the book or other item on the
deck in the correct position for
processing (shown at right). See
Placement of Items on the Deck –
General Guidelines.
Correct Position For Processing
The system checks for a digital identification tag or bar code.
j If a digital identification tag is present, the workstation reads the tag.
k If a digital identification tag is not present, the workstation goes into
scan mode, which means the bar code scanner will be turned on
after a short delay and the workstation reads the bar code.
Depending on the configuration of the software
wedge, you will be prompted to select a target
application in the Select Target Application
window to the right. This determines which
application receives the item ID, or other
information. To set the target application, refer to
the Software Wedge section of this guide.
Select Target Application window
5 You will hear a sound.
The workstation emits several distinctive sounds:
§ a Thump Sound produced when two adjacent non-edge sensors are
covered and an item is secured/un-secured.
§ a Beep Sound produced if the security strip in the item was not
secured or un-secured (for example, for a video).
§ an Error Sound or Warning Sound to indicate that error or warning
conditions are detected.
6 Remove the item and place the next item on the deck for processing.
§ After you hear the thump sound or beep sound, remove the item and
place the next item on the deck. If an error/warning sound occurs,
follow the on-screen instructions.
7 To continue processing items, repeat Steps 4 - 6 above.