User's Manual

75-0500-4450-4 C, 060-A 31
Secure/Un-secure Only (if enabled)
Item types can be secured/un-secured automatically, secured/un-
secured only after confirmation, or never secured. These settings can
be modified in administrative settings. Refer to the 3M Digital Staff
Workstation Model 795 Administrator Guide.
To secure items only
The following steps will secure an item without sending the item ID to the
library circulation system.
1 Go into Check-in mode:
For the Standard configuration:
§ Select the button. The message “Present Item(s)” appears
in the message area on the screen.
§ Select the (Send ID) button to turn OFF sending IDs and
follow the instructions on the screen.
For Local and Remote configurations with the Companion UI:
• Click Secure only in the Operations menu
and follow the instructions on the screen.
Companion UI - Operation menu
2 Place an item on the deck within the designated area.
The item should be:
§ touching the back wall (for books, the spine should be touching the
back wall),
§ within or inside of the edge sensors on the deck, and
§ covering two adjacent non-edge sensors (sensors that are next to each
other).
3 Position the item until the digital identification tag is read or the bar code
is under the scan line.
4 When the digital identification tag is read or the bar code is scanned, you
will hear a thump sound, which indicates that the security strip in the item
was secured.
For items requiring user confirmation to be secured, a variable button
appears in the Message area requesting user confirmation. An
example would be items long enough to cover the edge sensors. Other
non-standard conditions may occur if fewer than the expected number
of items is detected, or if a partial set is detected.