Operator’s Guide PocketProjector 3M MPro120 ™ 3
English 3M™ Pocket Projector MPro120 2 © 2009 3M. All Rights Reserved.
English 3M™ Pocket Projector MPro120 Contents Intended Use Statement.......................................................................................... 4 Trademarks and Copyrights..................................................................................... 4 Safety Information................................................................................................... 4 Safety Labels . ....................................................................................................
English 3M™ Pocket Projector MPro120 Intended Use Statement The 3M™ Pocket Projector MPro120 is designed to operate with the 3M-specified battery and 3M battery charger and in a normal office and home environment. • 10˚–35˚C (50˚–95˚F) • 10–80% RH (without condensation) • 0–1829 m (0–6000 feet) above sea level The ambient operating environment should be free of airborne smoke, grease, oil and other contaminants that can affect the operation or performance of the projector.
English 3M™ Pocket Projector MPro120 m Warning To reduce the risk associated with hazardous voltage: • Do not modify this product in any way. Use only 3M approved replacement components. • Do not attempt to service this projector other than battery replacement. There are no user serviceable parts other than the battery. Service to be performed only by a 3M-authorized service provider using 3M-approved system components. • Do not use the wall power supply in a wet environment.
English 3M™ Pocket Projector MPro120 m Warning To reduce the risk associated with fire and explosion, battery leakage or overheating: • Do not immerse the battery in water or allow to get wet. • Do not reverse the positive(+) and negative(-) terminals. • Do not connect the battery directly to a wall outlet. Use only the 3M-specified wall charger or automobile charger. • Do not strike, throw or subject the battery to physical shock. • Do not pierce the battery or break it open.
English 3M™ Pocket Projector MPro120 Safety Labels X X X X X X X X X X X X X X X X X X X LITHIUM ION POLYMER BATTERY Model No. BLP508-001 3.7V 2200mAh 8.1Wh P/N 78-6972-0004-2 m Warning • Use a specified charger. • Do not throw the battery into fire or heat. • Do not short-circuit the battery terminals. • Do not disassemble the battery. Charging Specification Standard Charge 0.44A/4.2V Cut Off Current 44mA Max Charge 2.2A/4.
English 3M™ Pocket Projector MPro120 FCC STATEMENT - CLASS B This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual may cause interference to radio communications.
WEEE Statement The following information is only for EU-members States: The mark shown to the right is in compliance with Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE). The mark indicates the requirement NOT to dispose the equipment as unsorted municipal waste, but use the return and collection systems according to local law. RoHS Statement 3M Projection Systems can provide RoHS certification for products meeting the RoHS directive.
English 3M™ Pocket Projector MPro120 Package Contents 1 3M Pocket Projector MPro120 2 Table Top Tripod 3 Rechargeable Battery 4 Carrying Pouch 5 Outlet Adapters (4) 6 Power Adapter 7 AV Adapters 8 Product Warranty and Safety Guide 9 Quick Start Guide 10 AV Cable 11 VGA-Audio Cable 2 1 4 3 6 5 8 9 7 10 10 11 © 2009 3M. All Rights Reserved.
English 3M™ Pocket Projector MPro120 Parts 1 Power Button 2 Brightness Mode Button 3 Volume Down Button 4 Volume Up Button 5 Battery Status Button 6 Status Indicator 7 Focus Wheel 8 Lens 9 Speaker 10 VGA-AV Input 11 DC Power Input 12 Battery Cover 13 Tripod Socket 14 Flip Stand © 2009 3M. All Rights Reserved.
English 3M™ Pocket Projector MPro120 Getting Started Install Battery The 3M MPro120 comes with a rechargeable battery. The battery is quick and easy to install and comes partially charged. To install the battery: slide the back cover off, insert the battery, and reinstall the cover. Important Note: Use only the 3M-specified battery: 78-6972-0004-2. Battery Maintenance Tips: • Remove the battery when the projector will not be used for one or more weeks.
Power Adapter The power adapter is used to charge the battery or power the projector. There are four outlet adapters to give you the flexibility to power the 3M MPro120 in most countries. You can also power the projector with the 3M MPro120 Car Charger, available separately. Installing An Outlet Adapter Onto The Power Adapter 1 Select the outlet adapter that will plug into your wall outlet. 2 Align the outlet adapter to the power adapter.
English 3M™ Pocket Projector MPro120 Charge the Battery The 3M MPro120 rechargeable battery gives you up to 4 hours of battery life in normal brightness mode. When the battery needs to be charged, the Status Indicator will flash red. The battery is charged by connecting the 3M MPro120 power adapter to the projector. 1 Turn the projector power off. 2 Connect the power adapter to the projector’s DC in. 3 Connect the other end of the power adapter into the electrical outlet.
English 3M™ Pocket Projector MPro120 Making Connections Connecting to a Composite Video Device Use the AV Cable to input video from camcorders, digital cameras, DVD players and digital media players into the VGA - AV input on the projector. 1 Connect the AV cable to the projector’s VGA-AV input. 2 Connect the other end of the AV cable to the video device’s audio and video outputs.
English 3M™ Pocket Projector MPro120 Connecting to a Component Video Device For component video input, you must purchase the optional 3M MPro120 Component AV Cable. This cable sends a higher quality video signal for the best possible image. 1 Connect the Component AV cable to the projector’s VGA-AV input. 2 Connect the other end of the AV cable to the video device’s audio and video outputs. Important Note: There are two red connectors on the Component AV cable.
English 3M™ Pocket Projector MPro120 Tip: Some video devices do not have the standard audio and video connections and may require an AV cable specified by the manufacturer. The AV cable allows you to connect your video device to your TV monitor or your projector and may be purchased from the video device manufacturer. Once you have the AV cable, you may need the cable adapters to connect the video device cable and the projector cable. Some video devices, by default, will not output a video signal.
English 3M™ Pocket Projector MPro120 Connecting to a Computer Use the VGA-Audio cable to connect the projector to desktop computers, laptop computers, ultra-portable computers and some personal digital assistants (PDAs). The projector supports VGA, SVGA, XGA, and WXGA resolutions. 1 Connect the VGA Cable to the MPro120 projector. 2 Connect the VGA Cable to the computer’s video and audio outputs. 3 Set the computer resolution to one of the supported resolutions.
English 3M™ Pocket Projector MPro120 Operating Instructions Powering On Press and hold the power button for 3 seconds. Release the power button when the projector begins to project an image and the status indicator turns green. 00:03 Tip: The video output on some devices is turned off by default. Please refer to the device’s documentation for details on enabling the video output. Powering Off Press and hold the power button for 3 seconds. Release the power button when the projected image is gone.
English 3M™ Pocket Projector MPro120 Adjusting Image Size The 3M MPro120 can project an 8 to 50 inch (203–1270 mm) diagonal image. Refer to the chart below. Diagonal SIze Image Width Image Height Projector-to-Screen Distance 8 in (20.32 cm) 6 3/8 in (16.2 cm) 4 3/4 in (12.2 cm) 6 3/4 in (17.0 cm) 14 in (35.56 cm) 11 1/4 in (28.4 cm) 8 3/8 in (21.3 cm) 11 3/4 in (29.9 cm) 20 in (50.8 cm) 16 in (40.6 cm) 12 in (30.5 cm) 16 3/4 in (42.7 cm) 26 in (66.04 cm) 20 3/4 in (52.
Changing the Brightness Press the Brightness button to switch between normal brightness (conserves battery power) and high brightness (increases light output by 20%). An icon will appear on the screen to indicate the current setting. High Brightness Low Brightness Adjusting the Volume Press the Volume up or Volume down button to adjust the sound. A volume bar will appear on the screen to help you set the volume level. Checking the Battery Level To check the battery, press the Battery Status button.
English 3M™ Pocket Projector MPro120 Attaching the Tripod The projector includes a table top tripod that mounts to the bottom of the projector. Tip: The 3M MPro120 will attach to most camera tripods. Cleaning Projector 1 Turn off the projector and disconnect power and other cables. 2 Use a soft cloth such as the 3M™ High Performance Cleaning Cloth to wipe off dust. If the dust is difficult to remove, dampen the cloth with clean water and then wipe the projector clean.
Status Indicator Lights and On Screen Icons Icon Description/ Meaning The projector is waiting for the A/V cable to be connected. The projector detects the audio/video cable. The projector detects an NTSC video input signal. NTSC The projector detects a PAL video input signal. PAL The projector detects the component audio/video cable. RGB 480i 60Hz The projector detects the video input signal and displays the video source’s resolution and refresh rate below the component icon.
English 3M™ Pocket Projector MPro120 Troubleshooting The projector will not turn on. • The battery is not installed or the power adapter is not connected to the projector and a working wall outlet. Test the electrical outlet by plugging another electrical device (like a radio) into the wall outlet and confirm that the wall outlet works. • The battery is installed in the wrong orientation. See “Install Battery” on page 12. • Hold down the power button until the projector powers up.
A computer is connected to the projector but the projector will not display the computer’s image. • Unplug the VGA-Audio cable from the projector and a white image with the 3M logo will display. • Plug the VGA – Audio cable into the projector and the icon in the upper-left corner of the image will change from a “waiting on cable” to the “VGA-Audio cable” icon. See “Status Indicator Lights and On Screen Icons” on page 23. The projector is making a noise.
English 3M™ Pocket Projector MPro120 Specifications Projector Description Imager Specification Technology LCOS Size 9.4 mm (0.37") Resolution 640 x 480 Pixels Aspect Ratio 4:3 Projection Distance 6 ¾ in. – 42 in. (171–1067 mm) Image Size 8 in. – 50 in. Diagonal Throw Ratio (Diagonal: Distance) 0.84:1 Lens Offset 1:1 (none) Inputs DC-in, VGA-AV Compatible Resolutions VGA, SVGA, XGA, WXGA Vertical Scan Rate 60 Hz Horizontal Scan Rate 31.5 kHz – 49.
English 3M™ Pocket Projector MPro120 BLP508-001 Rechargeable Lithium-Ion Battery Description Specification Type (BLP508-001) Rechargeable Lithium-Ion Polymer Battery Rated Capacity 3.7V 2200 mAh, 8.1 Wh Dimensions 62.4 x 53.8 x 10.5 mm Important Note: Do not throw battery into trash.
English 3M™ Pocket Projector MPro120 Limited Warranty • The 3M™ Pocket Projector MPro120 (the “3M product”) is warranted to be free from defects in material or manufacture for a period of 1 year from the date of purchase. • All other accessories included with the 3M product are warranted to be free from defects in material or manufacture for a period of 1 year from the date of purchase. • Optional product accessories that are not sold as part of the 3M product are subject to individual warranties.
b. 3M product is designed to operate in the typical indoor environment. This warranty does not cover 3M product used outside of the following circumstances: • 100V–240V AC, 50/60 Hz • 10˚–35˚C (50˚–95˚F) • 10–80% RH (without condensation) • 0–1829 m (0–6000 feet) above sea level c. The air intake and exhaust vent must be clear of obstructions. Inadequate air ventilation will cause the 3M product to malfunction or will cause damage to the 3M product which will void the warranty. d.
English 3M™ Pocket Projector MPro120 EXCEPT AS SPECIFICALLY STATED IN THE APPLICABLE 3M PRODUCT MANUAL, 3M SHALL NOT BE LIABLE FOR ANY INDIRECT, INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, LOSS OF PROFITS, REVENUE OR BUSINESS) RESULTING FROM, OR IN ANY WAY RELATED TO PERFORMANCE, USE OR INABILITY TO USE ANY OF THE 3M PRODUCT. This limitation applies regardless of the legal theory upon which damages are sought.
English 3M™ Pocket Projector MPro120 © 2009 3M. All Rights Reserved.
3M is a trademark of 3M Company. 3 Projection Systems 3M Austin Center 6801 River Place Blvd. Austin, TX 78726-9000 866-631-1656 www.3M.com/meetings meetings@mmm.com Please Recycle. Printed in USA. © 3M 2009. All Rights Reserved.
