User's Manual

Installation 13
5.2 Control Switch Module Installation
This subsection describes the installation of the
control switch module. It also describes how to
connect the vehicle equipment cable from the
Radio/GPS module to the control switch module.
Please read and fully understand the following
precautionary paragraphs before installing the
vehicle equipment control switch module.
•= Installations may include a customer-supplied
disable switch in addition to the control switch
module. The Disable feature turns off radio
transmission when the disable switch closes to
battery negative or positive. This feature typically
uses an existing switch that indicates the presence
of conditions deemed appropriate to disable radio
transmission. Such conditions include putting the
transmission in park, setting the parking brake, or
opening the vehicle operator’s door.
•= The control switch module location must be
readily accessible and visible to the vehicle
operator.
•= The control switch module must not be in the
path of airbag deployment.
•= The cable is routed between the Radio/GPS
module, the control switch module, the disable
switch, the vehicle turn signals, the light bar
switch, and the battery.
•= Use care when drilling holes to avoid drilling
into undesirable locations.
1. Determine the desired location to mount the
vehicle equipment control switch module. Mark
and drill two 7/32-inch holes, using the vehicle
equipment control switch mounting bracket as a
template.
2. Insert the two 10-32 x 3/4-inch cap screws
through the holes in the mounting bracket and
mounting surface. See Figure 5-1.
3. Use the two lock washers and 10-32 nuts to
secure the bracket to the vehicle.
Figure 5-1. Control Switch Module Mounting Bracket Installation