User Guide

3M
™
PanelSafe
™
Lockout System Accessories
One Way Pin
A one way pin is used to lockout an individual circuit located on either
the left or right side of the panel. Available 5 per package
or bulk, 15 per package.
Two Way Pin
A two way pin is used to lockout two circuits directly opposite each
other. Available 5 per package or bulk, 15 per package.
Hook Pin
The hook pin can be used to secure “on” individual circuits (i.e.
dedicated passive circuits), or to lockout individual circuits from either
the left or right side of the panel. Available 5 per package
or bulk, 15 per package.
PS-SP Spade Pin
A spade pin is used to lockout on either the left or right side of the panel
when the measured distance from the center line of the dead front to the
max position on the breaker handle in the off position is greater than 2
1/2". Available 5 per package or bulk, 15 per package.
PS-SP05 Half-size Spade Pin
The half size spade pin is used to lockout half-size (twin or piggyback)
breakers. This pin can lockout an individual circuit by simply rotating
the pin 180° for either the top or the bottom breaker. Available 5 per
package or bulk, 15 per package.
Cup Pin
The cup pin is used to secure “on” individual circuits (i.e., dedicated
circuits) located on either the left or right side of the panel. Available 5
per package or bulk, 15 per package.
Pin Holder
Stores all pins, (except main breaker pin) at each panel location
for easy access when lockout functions are required.
Standard Shim
On distribution panels where the body of each breaker extends out
beyond the level of the dead front, the standard shim is used to raise the
surface, where a 3M
™
PanelSafe unit is mounted, level with the body of
each breaker. Available only in pairs.
2-1/2"
PS-1P
PS-2P
PS-HP
PS-SP
PS-SP05
PS-CP
2-1/2"
3"
2-1/2"
3-1/2"
3"
3-1/2"
PS-PH
PS-SH1
1/8"
3M
™
offers various pins, shims and brackets, so that the PanelSafe
Lockout System can be used, even if the panel front is not flat.