User Guide

The PowerCart offers flexibility, performance and value unequaled by any other system. This system uses self propelled
carts traveling along a 1/2" high floor track that enables easy access into your finishing area. Each PowerCart is
independent, allowing it to easily roll over and be removed off the track so you can add and remove carts form the line at
your convenience. You can stop a PowerCart at anytime and the second it touches anything, it immediately comes to a
gentle stop. Attached to the track are Line Stops that activate a time delay switch inside the PowerCart. This adjustable
time delay can be set from seconds to minutes. The Line Stops are easily attached to the track and placed at any point
where you wish the PowerCart to stop. Each PowerCart has Stop Bars on the sides of the rotating platform that depress
when another cart pushes against them and stops the PowerCart immediately. Once the Stop Bar is released, the
PowerCart will wait until the time delay period is over and then proceed. An operator can stop a PowerCart at anytime by
simply pushing the Stop Bar. When removing a PowerCart from the line, lift the drive wheel handle and roll the PowerCart
over the track and thru your facility. At the end of the day or during breaks, the operator deactivates the PowerCart by
pushing it's ON/OFF switch and all other carts will stop and deactivate in line behind it. The PowerCart track is easily
installed and easy to lengthen. A complete system can be installed in one day at very little cost and you can reconfigure
your finishing system at anytime. Click below to see a schematic of a typical PowerCart installation.
Prime Heat, Inc Phone: [phone]
1844 Friendship Drive, El Cajon, CA 92020 Fax: [phone]