Instruction Manual

7
2.0 Maintenance, Service, and Storage
2.1 BATTERY REPLACEMENT: The CGC Hook is powered by a 9 Volt Battery. Battery life will vary with frequency of use and
the environmental conditions in which the CGC Hook is used and stored. Under normal use conditions, the battery should
be replaced when the blue LED “low battery” pattern is blinking, as described in Section 2.1, “Blue LED Blink Patterns”.
Replace discharged batteries promptly. Replace the battery with a 9V alkaline or 9V non-rechargeable lithium battery. Use
of any other type of battery may present risk of re or explosion.
;
Lithium Battery Usage: If a Lithium Battery is used in this device, it may present a risk of re or chemical burn if
mistreated. Do not disassemble, heat above 130° F (54° C), or incinerate.
Figure 5 illustrates replacement of the battery. To replace the battery:
1. Remove the four screws securing the Battery Cover and remove the Battery Cover. Save the screws for reuse.
2. Pull the Battery and Battery Connector Wire out of the enclosure, taking care not to damage or pinch the Battery
Connector Wires.
3. Disconnect the Battery from the Battery Connector. Dispose of the Battery properly. Keep away from children. Do not
disassemble the Battery or burn in a re for disposal.
4. Connect the Battery Connector, observing proper polarity of the battery and connector.
5. Insert the Battery into the enclosure. Take care not to damage or pinch the Battery Connector Wires. When fully
inserted, the Battery should sit below the surface of the enclosure to allow for proper installation of the Battery Cover.
If the Battery is not positioned properly in the enclosure, reinsert the Battery, ensuring the Battery Connector Wires
are not obstructing proper insertion of the Battery.
6. Inspect the Battery Cover to ensure the Gasket (A) is present on the inside of the cover and is in good condition.
Reinstall the Battery Cover and secure with the four screws. Do not overtighten the screws.
2.2 SERVICE: Additional maintenance and servicing procedures must be completed by an authorized service center. Do not
attempt to disassemble the CGC Hook or lubricate any parts.
3.0 Labels and Markings
Figure 6 illustrates labels and markings on the the Comfort Grip Connected Hooks and their locations. All labels must be present
on the CGC Hook. Labels must be replaced if they are not fully legible.