Installation Manual

ManualsBrands3M ManualsElectronicsCommunication Module

HUB-1CX Installation Manual

FCC ID of this product is as follows.

FCC ID: DGFPSDHUB1CX

IC:458A-PSDHUB1CX

For OEM integration only – device cannot be sold to general public.

Therefore, we will ask OEM to include the following statements

required by FCC on the product and in the Installation manual

Notice.

Summary of content (5 pages)

PAGE 1
HUB-1CX Installation Manual FCC ID of this product is as follows. FCC ID: DGFPSDHUB1CX IC:458A-PSDHUB1CX For OEM integration only – device cannot be sold to general public. Therefore, we will ask OEM to include the following statements required by FCC on the product and in the Installation manual Notice.
PAGE 2
Contents 1.Voltage 2.Antenna 3.Notice 1. Voltage min. typ. max. unit Specification Temperature Range - 40 +25 +85 deg.C Specification Voltage VBAT 3.0 3.6 4.8 V VDDIO 1.71 1.8 or 3.3 3.63 V .
PAGE 3
2.Antenna Please perform the antenna design that followed the specifications of the antenna. The concrete contents of a check are the following three points. １） It is the same type as the antenna type of antenna specifications. Confirm the same size as the Gerber file. ２） An antenna gain is lower than a gain given in antenna specifications. Measure the gain, and confirm the peak gain is less than the application value (1.4dBi) ３）The emission level is not getting worse.
PAGE 4
For OEM integration only – device cannot be sold to general public. Therefore, we will ask OEM to include the following statements required by FCC/IC on the product and in the Installation manual Notice. Please describe the following warning on the final product which contains this module. Contains Transmitter Module FCC IC:DGFHUB1CX Contains Transmitter Module IC:458-PSDHUB1CX Please describe the following warning to the manual. This device complies with part 15 of the FCC Rules.
PAGE 5
This device is intended only for OEM integrators under the following conditions: 1)The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2)The transmitter module may not be co-located with any other transmitter or antenna. 3)The use of an antenna with gain less than 1.4 dBi. As long as 3 conditions above are met, further transmitter test will not be required.