3 Jet-Weld Thermoset Adhesive System ™ Hot melt speed and structural strength performance for wood, metal, many plastics, and more.
Thin bond lines at hot melt speeds with The hand-held 3M ™ Jet-Weld ™ II Adhesive Applicator and moisture-curing urethane adhesives put a powerful production capability in your assembly operation. This single system combines production benefits typical of hot melt adhesives and bond performance usually associated with 2-part structural adhesives. Benefits typical of hot melt adhesives • Fast initial set and handling strength in as few as 15 seconds helps eliminate or minimize fixturing, and speed assembly.
holding power up to a half ton E G 8 6 5 D 9 H F 7 • Gliding windows (E) – Fast handling strength helps speed bonding of interior wood trim to vinyl sash. • Speaker cones (F) – Flexible, tough bond lines hold dissimilar materials and multiple components. • Decorator tables (G) – One-component eliminates fixturing in multi-tasks including V-groove bonding at the table joints, and laminating tops.
Wide adhesive selection with strength gr Select adhesives and containers to meet your specific requirements (A) 11 Hard-to-find structural strength bond lines 10 TE-015, TE-030, TE-100, and TE-200 adhesives are your primary choices for wood bonding. For bonding plastics, you’ll want to consider TE-031, TS-040, TS-115 HGS, and TS-230. All 3M ™ Jet-Weld ™ Adhesives are available in 10 fl.oz. cartridges for use with the 3M Jet-Weld II Applicator.
reater than many substrates 3M™ Jet-Weld™ Adhesive Information Product Description Application Viscosity Temperature TE-015 Extrudable. Very fast set time for bonding wood and selected plastics. 250°F (121°C) TE-030 Extrudable. Fast set time. Best for bonding wood and selected plastics. TE-031 Shore Tensile Strength D Color Open Time Set Time 7,000 cps White/ off white 1.5 min. 15 sec. 65 250°F (121°C) 16,000 cps White/ off white 1 min. 30 sec. Extrudable.
Trigger a bead – fast, easy and neat Get off to a fast start... and finish with no purging 3M ™ Jet-Weld ™ Adhesive cartridges are simply loaded into the rear of the handy self-contained 3M™ Jet-Weld II™ Applicator. The applicator end cap twist-locks the cartridge into position. For improved productivity, the optional Jet-Weld Adhesive preheater keeps up to four adhesive cartridges ready to use. That means you can keep one to four Jet-Weld applicators operating full time.
• Impact-resistant plastic construction is engineered for lightweight handling ease and the hard realities of the shop and plant. • 100% solids 3M™ Jet-Weld™ Adhesive is applied molten at only 250°F (121°C). No temperature adjustments required. • Open time up to 10 minutes allows product positioning. • Set time as fast as 15 seconds helps eliminate or minimize fixturing. • Handle fits most hand sizes and is positioned to help balance the applicator.
