User Guide

Wide adhesive selection with strength gr

Select adhesives and containers to meet your specific requirements

Hard-to-find structural

strength bond lines

TE-015, TE-030, TE-100, and TE-200 adhesives are your primary choices for wood bonding.

For bonding plastics, you’ll want to consider TE-031, TS-040, TS-115 HGS, and TS-230.

All 3M

™

Jet-Weld

™

Adhesives are available in 10 fl.oz. cartridges for use with the 3M

Jet-Weld II Applicator. Some Jet-Weld Adhesives are also available in 2k foil packs, gallon

pail, 5-gallon pail, and 55-gallon drum.

™

Jet-Weld

™

Adhesive speed decreases fixture time to help increase productivity. In only 10

minutes, bond strength exceeds the structural strength base line of 1,000 psi in lap shear.

After an hour, strength is greater than many substrates (note splice test at right).

In a test of two pieces of oak (A) edge-

spliced with 3M Jet-Weld Adhesive, the

bond line is neat, and clean (B). Even

with close scrutiny of the edge and stained

surface, the bond line is hard to find.

(A)

(B)

(C)

Ultimate bond strength depends on the

adhesive and substrate. But in this edge-

splice test using 3M Jet-Weld Adhesive

and many other applications, the substrate

will fail before the bond (C). See data

sheets for additional technical information

about 3M Jet-Weld Adhesives.

3M Jet-Weld Adhesive*Strength Build-up (Lap Shear)**

Versus Typical Conventional Adhesives

1500

1000

500

psi

5 min 10 min 15 min 30 min 1 hr 2 hr

Jet-Weld Adhesive 2-Part Epoxy

Hot Melt

PVA

***

Note: This technical information and data should be considered representative or typical only

and should not be used for specification purposes.