User Guide

• Job matched tips change with a few
simple turns of a common wrench.
Tip selection includes the following:
1) Threaded cap for sealing tip
after use.
2) 0.072" orifice (1.25" long)
extension tip for improved sight
line in hard-to-reach areas.
3) 0.062" orifice for low flow
applications.
4) 0.125" orifice for high flow
applications.
0.090" orifice tip comes standard
with the applicator.
Trigger a bead – fast, easy and neat
Get off to a fast start...
and finish with no purging
3M
™
Jet-Weld
™
Adhesive cartridges are
simply loaded into the rear of the handy
self-contained 3M
™
Jet-Weld II
™
Applicator.
The applicator end cap twist-locks the
cartridge into position.
For improved productivity, the optional
Jet-Weld Adhesive preheater keeps up to
four adhesive cartridges ready to use. That
means you can keep one to four Jet-Weld
applicators operating full time.
With pre-heated adhesive, a simple squeeze
of the trigger immediately starts the
application of the adhesive at up to 11
pounds per hour.
At the end of operation, there’s no purging
of the applicator.
• Applicator rest holds applicator upright
when not in use. Frees both hands for
component assembly.
• Tool balance – For worker comfort
during extended use, the applicator can
be balanced and supported from above
to effectively decrease the weight.
1
2
3
4
14
15
16
17
18
19