User Guide

ManualsBrands3M ManualsOtherSCOTCH-WELD STRUCTURAL ADHESIVES DEMO GUIDE HR

Industrial Adhesives and Tapes Division

3M Center Bldg. 21-1W-10

900 Bush Ave.

St. Paul, MN 55144

1-800-362-3550

www.3M.com/adhesives

Printed in U.S.A.

78-9236-7113-1

PRODUCT USE: All statements, technical information and recommendations contained in this document are based upon tests or experience that 3M believes

are reliable. However, many factors beyond 3M’s control can affect the use and performance of a 3M product in a particular application, including the

conditions under which the product is used and the time and environmental conditions in which the product is expected to perform. Since these factors

are uniquely within the user’s knowledge and control, it is essential that the user evaluate the 3M product to determine whether it is fit for a particular

purpose and suitable for the user’s method of application. WARRANTY AND LIMITED REMEDY: 3M warrants that each 3M product meets the

applicable specifications at the time 3M ships the product. 3M MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT

LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR ANY IMPLIED WARRANTY ARISING

OUT OF A COURSE OF DEALING, CUSTOM OR USAGE OF TRADE. User is responsible for determining whether the 3M product is fit for a particular

purpose and suitable for user’s application. If the 3M product is defective, your exclusive remedy and 3M’s and seller’s sole obligation will be, at 3M’s

option, to repair or replace the product or refund the purchase price. LIMITATION OF LIABILITY: Except where prohibited by law, 3M and seller will

not be liable for any loss or damage arising from the 3M product, whether direct, indirect, special, incidental or consequential, regardless of the legal

theory asserted, including warranty, contract, negligence or strict liability.

™

EPX Plus Applicator

• Applies two-part adhesives with a

squeeze of the trigger

• Nozzle simultaneously meters, mixes,

and dispenses adhesive

• Lightweight yet rugged industrial

construction

Stabilize and rigidize wires inside copper

electronic sub-component. Try pulling out the

encapsulated wires by hand. Note that the adhesive

is non-corrosive to copper.

™

Scotch-Weld

™

Potting

Compound Adhesive DP-270

• 2-part rigid epoxy potting compound

• Low viscosity fills cavities and self levels

• Meets UL-94 HB Flammability Test

Easy to use. Hold up the plunger release

above the handle and slide the plunger into

the slot. The end with the round hole goes in

and through the applicator. Place the adhesive

cartridge into the retainer slots and close the

cartridge collar. Slip a nozzle into the retainer

slots on front of the cartridge and rotate the

nozzle to lock into place.

Note

self-leveling

and non-corrosiveness to copper

Demonstrate

ease of

use