Manualshelf

Operation Manual

ManualsBrands3M ManualsProjectorsSCP716
12345678910
10
Operator’s Guide
3M
™
Super Close Projection System SCP716
© 3M 2009. All Rights Reserved.
ENGLISH
D WARNING
To reduce the risk associated with hazardous voltage:
Do not operate this projector in wet environments or outdoors.s
Do not modify this projector or power cord.s
Do not remove any screws other than those specified in the lamp replacement instructions.s
Do not attempt to service the projector other than the lamp cartridge. There are no user serviceable s
parts inside the projector.
Contact a 3M authorized service provider for service.s
Disconnect power cord when the projector is not in use for extended periods of time, during lamp s
replacement, and while cleaning.
Do not allow water or other liquids to enter the projector.s
To reduce the risk associated with hazardous voltage and/or fire:
Replacs e power cord if damaged.
Contact a 3M authorized service provider if the projector becomes damaged.s
Use a grounded extension cord with a rating at least equal to that of the projector.s
Connes
ct this projector to a grounded outlet.
To reduce the risk associated with choking:
Keep the battery and battery cover away from children and pets.s
To reduce the risk associated with lamp rupture related hazards:
In evs ent of lamp rupture, call 3M authorized service provider for repair. Ruptured lamp repair is not
user serviceable.
Wash your hands thoroughly if contact with ruptured lamp debris has taken place.s
Ventilas
te the area where the lamp rupture occurs. The lamp operates at high temperature.
To reduce the risk associated with hazardous voltage, impact, tripping, or intense visible light:
Do not use this projector around unsupervised children.s
To reduce the risk associated with sharp objects, premature lamp failure, exposure to mercury:
Alwas ys handle the fragile lamp module with care.
Replace the lamp module when the lamp replacement message appears.s
Never replace the lamp module with a previously used lamp module.s
Remos
ve the projector from the ceiling or wall mount before replacing the lamp.