Owner manual
© 3M 2008. All Rights Reserved. 31
3M™ Super Close Projection System User Controls
RS232 Command
RS232: Allow RS232 control of an individual projector.
RJ45: Allow network LAN via web browser (Internet Explorer) to
control of projector. (Default setting)
Projector ID
ID denition can be set up by menu (range 01~99), and allow user
control an individual projector by RS232. Refer to page 49 for the
complete list of RS232 commands.
Signal Power On
On: The projector will automatically power on when plug in any
signal source to the projector at standby mode.
Off: Turn on the projector to normal mode.
Direct Power On
Choose “On” to turn on Direct Power On mode. The projector will
automatically power on when AC power is supplied, without pressing
the “Power/Standby” key on the projector control panel or “Power”
key on the remote control.
Eco. Standby
3.7W: Save power dissipation further.
5.3W: Return to normal standby mode.
Management-3/3
• When “Signal
Power On” is
enabled, Eco.
Standby Mode
will be auto set as
5.3W.
• When “Eco.
Standby” mode is
enabled (3.7W),
the Signal Power
On function is
disabled.