Datasheet

(5)
3M
™
Bumpon
™
Protective Products - Molded Shapes - Colored and Clear
Series SJ5000
•
SJ5300
•
SJ5400
•
SJ5500
•
SJ5700
•
SJ6100
Relative Adhesive Performance Characteristics
Note: The following technical information and data should be considered representative or typical only and should
not be used for specification purposes.
3M™ Bumpon™ Protective Products
SJ5000
SJ5500 SJ5300
SJ5700 SJ5400 SJ6100
Adhesive:
Natural Rubber Acrylic Synthetic Rubber
R-30 A-20 R-25
Initial Adhesion
Low Surface Energy: Good Poor Excellent
High Surface Energy: Good Fair Excellent
Adhesion (Peel)
Low Surface Energy: Good Poor Excellent
High Surface Energy: Good Good Excellent
Static Shear
25°C (75°F): Excellent Excellent Excellent
49°C (120°F): Good Excellent Good
70°C (158°F): Poor Excellent Fair
Dynamic Shear: Good Excellent Good
Solvent Resistance: Good Excellent Good
Adhesive Performance
Note: The following technical information and data should be considered representative or typical only and should
not be used for specification purposes.
The following table on peel adhesion provide representative performance characteristics of the adhesive
systems used in the construction of 3M™ Bumpon™ Protective Products molded series products.
* 3M Test Method TM-2011; 72 hour dwell, 1/2 inch wide samples pulled at 12 inches per minute. Testing completed using Bumpon Resilient Rollstock
products SJ5816, SJ6016, and SJ6216, which use the same adhesive system as the molded series products.
90° Peel Adhesion *Peel Force, oz. Per 1/2 inch
3M™ Bumpon™ Protective Products
SJ5000
SJ5500 SJ5300
SJ5700 SJ5400 SJ6100
Substrate:
Natural Rubber Acrylic Synthetic Rubber
R-30 A-20 R-25
Polypropylene 25 3 52
Polystyrene 25 11 55
ABS 25 25 55
Stainless Steel 22 25 55
Aluminum 22 25 55