Technical information

7
3.13 Remove the 3M
™
Universal Connector
Holder from the 3M Hot Melt Oven by
grasping the cool-touch handle.
Caution: Do not touch the metal portion of the
holder or connector, as it will be hot!
3.14 Feed the fiber into the back of the 3M Hot
Melt ST Connector, until the buffer stops
inside the connector.
3.15 Slide the clear strain relief tube into the
connector until it stops.
3.16 Push the buffered fiber into the cable
retention feature until secure.
3.17 Rest the connector holder in one of the
available cooling ports located on both sides
of the oven. Let cool for three minutes.
Proceed to Section 9: Scribing, Page 18.