User's Manual
Table Of Contents
- V-Series, R-Series, BCS Owner's Manual
- Safety information
- Intended use
- Safety information for V-Series Models 6410, 6420, 7410, and 7420
- Safety information for V-Series Tabletop Models 6412, 6422, 7412, and 7422
- Safety information for R-Series Model 8410
- Safety information for BCS Model 9410
- V-Series label locations
- V-Series Tabletop Unit label locations
- R-Series label locations
- BCS label locations
- Regulatory compliance
- Overview
- Touch screen monitor controls
- General maintenance
- Solving problems
- Obtaining service and supplies
- Appendix A: BCS scanner adjustment template
- Safety information
⎟ 11
Regulatory compliance
EMC compliance USA and Canada
FCC Radio Frequency Rules and Regulations
This equipment has been tested and found to comply with the limits for a Class A
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can emit
radiated radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful inter-
ference in which case the user will be required to correct the interference at their
own expense.
NO MODIFICATIONS. Modifications to this device shall not be made without the
written consent of The 3M Company. Unauthorized modifications may void the
authority granted under Federal Communications Commission Rules permitting
the operation of this device.
FCC Intentional Radiator Certification (Models 7410, 7420, 7412, 7422 and 8410only)
Model 7410: FCC ID: DGFSSD7410
Model 7420: FCC ID: DGFSSD7420
Model 7412 and Model 7422: FCC ID: DGFSSD7422
Model 8410: FCC ID: DGF-SSD8210
This equipment contains an intentional radiator approved by the FCC under the
FCC ID number shown above. This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Industry Canada radio frequency rules and regulations
This Class A digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du
Règlement sur le matériel brouilleur du Canada.
EMC compliance Europe
This equipment complies with the requirements of the EMC directive.
Australia
This unit complies with the EMC requirements for Australia.
Japan
同梱の電源コードは当該製品専用です。