User's Manual
Table Of Contents
- V-Series, R-Series, BCS Owner's Manual
- Safety information
- Intended use
- Safety information for V-Series Models 6410, 6420, 7410, and 7420
- Safety information for V-Series Tabletop Models 6412, 6422, 7412, and 7422
- Safety information for R-Series Model 8410
- Safety information for BCS Model 9410
- V-Series label locations
- V-Series Tabletop Unit label locations
- R-Series label locations
- BCS label locations
- Regulatory compliance
- Overview
- Touch screen monitor controls
- General maintenance
- Solving problems
- Obtaining service and supplies
- Appendix A: BCS scanner adjustment template
- Safety information
⎟ 3
CAUTION
To reduce the risk associated with environmental contamination due to the
incorrect disposal of the lithium battery in the PC, mercury in the monitor/
display, and/or any circuitry that contains lead in the solder:
At the end of service life, dispose of the V-cradle, coil driver box, interconnect box,
appliance coupler, computer, monitor, and laser scanner in accordance with
federal, state, and local requirements.
To reduce the risk associated with exposure to laser light due to a person
looking into the laser scanner:
Do not look directly into laser scanner device;
At the end of service life, dispose of laser scanner in accordance with federal,
state, and local requirements.
IMPORTANT NOTE
The Code of Federal Regulations (CFR) 21CFR1040.10 requires the following
statement for products containing lasers:
Caution—use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous laser light exposure.
Safety information for V-Series Tabletop Models 6412, 6422,
7412, and 7422
WARNING
To reduce the risk associated with fire due to a user or installer attempting to
service the SelfCheck unit:
Do not attempt to modify or repair—no user serviceable parts—contact 3M
Service for repair.
Use approved system components installed by 3M service personnel only.
To reduce the risk associated with hazardous voltage due to a user or installer
attempting to service the SelfCheck unit or use of the system when damage has
occurred to power cord:
Do not attempt to modify or repair—no user serviceable parts—contact 3M
Service for repair.
Use approved system components installed by 3M service personnel only.
Do not use the SelfCheck Tabletop unit if the power cord is damaged — contact
3M Service for repair.