User's Manual
Table Of Contents
- C-Series User Guide
- Safety information
- Regulatory compliance
- Overview
- Software installation
- Typical workflows
- Startup and shutdown
- Installing system security updates
- Managing the 3M™ SelfCheck™ System
- Home page
- Basic administration
- Advanced administration
- General maintenance
- Solving problems
- Obtaining service and supplies
- Appendix A: Email notification messages
8 ⎟
7
In the Install from Disk dialog box, browse to the
PRINTER\Ithaca\iTherm280\Drivers folder on the
CD, and then click OK.
8 Select Ithaca from the Manufacturers list and
Series 280 from the Printers list, and then click
Next.
9 In the Name Your Printer dialog box, name the
printer Series 280 and select it as the default
printer.
The printer must be named Series 280 for the
SelfCheck system diagnostics to work properly.
10 Click Next, and then click Next again.
11 If you want to print a test page, click Yes, and then
click Next.
12 Click Finish. If a message appears that says the
software has not passed Windows Logo testing,
click Continue Anyway.
7 Browse to PRINTER\Ithaca\iTherm280\Drivers
Configure the printer driver
1 In the Printers and Faxes window, right-click
Series 280, and then click Properties.
2 On the Start/EndDoc tab, set Line Feeds to 10 and
select Cut Receipt.
3 On the Advanced tab, click Printing Defaults.
2 Set Line Feeds to 10 and select Cut Receipt
4 On the Paper/Quality tab, click Advanced, and
then set Print Text as Graphics to On.
5 Close the Series 280 Properties dialog boxes by
clicking OK in each.
6 On the Windows Taskbar, click Start, and then click
Stop 3M SelfCheckCSeries.
4 Turn on Print Text as Graphics