User's Manual
Table Of Contents
- C-Series User Guide
- Safety information
- Regulatory compliance
- Overview
- Software installation
- Typical workflows
- Startup and shutdown
- Installing system security updates
- Managing the 3M™ SelfCheck™ System
- Home page
- Basic administration
- Advanced administration
- General maintenance
- Solving problems
- Obtaining service and supplies
- Appendix A: Email notification messages
10 ⎟
Typical workflows
Without DLA
Use the following procedure if you do not use a 3M Digital Library Assistant
(DLA).
1 Let the returns accumulate until the chute is full or a set time is reached.
2 Remove the returns, and then immediately click Items Removed on the
Current Items tab of the local interface.
3 Place any item that arrives between the time you remove the returns and
click Items Removed with the items you just removed.
4 View or print the exception report for the items, and use it to find the
items that need further processing.
5 Remove the exception slips from the printer and place them in the items
you sorted out.
6 Repeat.
With DLA
Use the following procedure if you use a DLA.
1 Let the returns accumulate until the chute is full or a set time is reached.
2 Remove the returns, and then immediately click Items Removed on the
Current Items tab of the local interface.
3 Place any item that arrives between the time you remove the returns and
click Items Removed with the items you just removed.
4 Remove the CompactFlash (CF) card from the reader attached to the
SelfCheck system computer, and then insert the other CF card supplied
with the system.
5 Use the DLA to find the items that need further processing.
6 Remove the exception slips from the printer and place them in the items
you sorted out.
7 Remove the CF card from the DLA for reuse.
8 Repeat.