User's Manual
Table Of Contents
- C-Series User Guide
- Safety information
- Regulatory compliance
- Overview
- Software installation
- Typical workflows
- Startup and shutdown
- Installing system security updates
- Managing the 3M™ SelfCheck™ System
- Home page
- Basic administration
- Advanced administration
- General maintenance
- Solving problems
- Obtaining service and supplies
- Appendix A: Email notification messages
⎟ 11
Startup and shutdown
Use the following procedures to start the SelfCheck system, to restart it, or to
shut it down.
Starting the 3M™ SelfCheck™ System
To start the SelfCheck system
Ensure power is applied to all components, and
then start the computer. The SelfCheck system
software and local user interface starts automatic-
ally after Windows loads. This may take a minute
or two.
To start the SelfCheck system software when the
computer is already running
1 On the keyboard, press the Windows key. The
Windows Start menu appears.
2 Click Start 3M SelfCheckCSeries.
Starting when the computer is running
Restarting the 3M™ SelfCheck™ System
Use Restart if you need to restart the SelfCheck
system service after changes to the operating system.
This command restarts the SelfCheck system software
and service. It does not restart the SelfCheck system
computer.
To restart using SelfCheck System Manager
1 Open SelfCheck System Manager. (See “3M™
SelfCheck™ System Manager” on page
20.)
2 On the Home page, type your password in the
Password box, and then click Login.
3 At the bottom of the screen, click Shutdown.
4 In the shutdown dialog box, click Restart.
Restarting from the Shutdown dialog box