User's Manual
Table Of Contents
- C-Series User Guide
- Safety information
- Regulatory compliance
- Overview
- Software installation
- Typical workflows
- Startup and shutdown
- Installing system security updates
- Managing the 3M™ SelfCheck™ System
- Home page
- Basic administration
- Advanced administration
- General maintenance
- Solving problems
- Obtaining service and supplies
- Appendix A: Email notification messages
40 ⎟
Retries
Retries are used only for the first exchange to establish the initial connection
to the host computer. Enter the number of times you want the SelfCheck sys-
tem to attempt to connect to the host if it does not succeed on the first attempt.
Devices
Use the Devices tab to set up the SelfCheck system’s
hardware devices, but only under the direction of 3M
support personnel.
After making any changes, click Save Device
Settings.
Printer
In SelfCheck System Manager, you can select only
printers that are installed in the SelfCheck system’s
operating system. 3M currently supports only the Ithaca
iTherm Series 280 printer. Though other printers can
be used to print hold slips, printer-level diagnostics are
not available for those printers.
To enable printing
Under Printer, select Enabled.
To disable printing
Under Printer, clear Enabled.
Devices tab
RFID reader
Because the 3M RFID reader is required, you cannot disable it or use a
different type of RFID reader.
To configure the RFID Reader
Type the number of the COM port that it is connected to (the default is
COM 1).
To adjust the other RFID reader properties, please contact 3M Technical
Support:
Removal delay
The default is 200 ms.
Detection interval
The default is 500 ms.