User's Manual
Table Of Contents
- C-Series User Guide
- Safety information
- Regulatory compliance
- Overview
- Software installation
- Typical workflows
- Startup and shutdown
- Installing system security updates
- Managing the 3M™ SelfCheck™ System
- Home page
- Basic administration
- Advanced administration
- General maintenance
- Solving problems
- Obtaining service and supplies
- Appendix A: Email notification messages
54 ⎟
General maintenance
Replacing the printer paper
When the printer runs out of paper, use the following procedure to install a
new roll of paper:
To replace the paper
1 Squeeze the open button and lift the printer cover.
2 Place the paper roll in the printer so the paper unwinds from the bottom.
3 Pull the front edge of the paper out until it is past the front edge of the
printer.
4 Close the printer cover.
To order printer paper rolls, see "Obtaining service and supplies" on
page
58.
6400
_
UG
_
04
SQ
UEEZE
TO OPEN
Opening the printer
Cleaning the components
The SelfCheck system components can become dirty with normal use and
may require cleaning. To clean the component exteriors, dampen a soft cloth
with water or a mild cleaning solution and gently wipe away dirt from the
affected areas.
Cleaning the monitor
Shut down the SelfCheck system.
Use care when cleaning the SelfCheck system monitor.
Use pre-moistened towelettes that are sold specifically for monitor
cleaning. If these are not available, you can use isopropyl alcohol or
water to dampen a soft cloth, but use it very sparingly.
Typically, an isopropyl alcohol and water solution ratio of 50:50 is the
best cleaning agent for the touch screen. You can also use straight
isopropyl alcohol. In addition, 3M™ Screen and Keyboard Cleaner
CL680 has been tested and approved for this use.