Pad Staff Workstation Model 895 PRERELEASE DOCUMENTATION Site Planning Guide 3M Security Systems Division 3M Center, Building 225-4N-14 St. Paul, Minnesota 55144-1000 78-8126-xxxx-x Rev 1 Copyright © 2004 3M IPC. All rights reserved.
Table of Contents Intended Use:......................................................................................................................... 3 Label Locations.................................................................................................................... 5 EMC, USA, and Canada Compliance ................................................................................... 6 FCC Radio Frequency Rules and Regulations................................................................
SAFETY INFORMATION Read, understand, and follow all safety information contained in these instructions prior to installation and use of the 3M™ Pad Staff Workstation Model 895. Retain these instructions for future reference. Intended Use: The 3M™ Pad Staff Workstation Model 895 is intended for use in check-in/check-out of library materials.
WARNING To reduce the risks associated with hazardous voltage contained within the power supply, which, if not avoided, could result in death or serious injury: § Do not use the power supply if the case or cord are damaged; § Do not use power supply in outdoor or wet environments; § Do not attempt to service or repair the RFID circuitry or power supply — no user serviceable parts inside.
Label Locations Model 895 12 VDC 300 mA S/N: 895XXXX N1108 3MTM RFID Reader Model 895 12 VDC 300 mA FCC ID: DGF-SSD895 Canada: __________ 3.6 W S/N: 895XXXX N1108 3 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
EMC, USA, and Canada Compliance FCC Radio Frequency Rules and Regulations This equipment has been tested and found to comply with the limits for a Class A device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Section 1 - Overview The 3M Pad Staff Workstation Model 895 is used with other equipment and software to read and/or program 3M RFID Tags.
Equipment specifications Reader pad Dimensions Length: 11.4 in. (28.9 cm) Width: 11.4 in. (28.9 cm) Height: 0.4 in. (1.0 cm) Weight 32 oz. (.91 Kg) Environmental Typical ambient temperature range: 50°F to 104°F (10°C to 40°C) Humidity: 0% to 85% RH, non-condensing Reader Dimensions Length: 5.6 in. (14.22 cm) Width: 5.0 in. (12.7 cm) Height: 1.0 in. (2.54 cm) Weight 3.64 oz. (103.
Cable lengths Serial cable § Each reader pad includes a standard 6.67-foot (2-meter) serial cable. § § If necessary, you can purchase standard serial cables up to 50 ft. USB to serial adaptor - if no serial ports are available, a USB-to-serial adaptor cable may be purchased and installed by your IT department. Reader pad cable The reader pad has a 6.67-foot (2-meter) cable. § If necessary, 25-foot (7.62-meter) extension cables are available from 3M (with the total length not to exceed 50 ft. (15.
Section 2 – Basic Operation Pad Staff Workstation Software The 3M™ Pad Staff Workstation software consolidates a number of library functions to enable staff to process items identified by 3M™ D8 RFID tags. The workstation reads item ID information from the tags and sends the information to the library circulation system. The Pad Staff Workstation software secures and un-secures tags as required.
Section 3 - Care and maintenance Cleaning the reader pad The reader pad may need occasional cleaning. § Gently rub the reader pad with a soft cloth dampened with a mild cleaning solution. § DO NOT use any abrasive cleaners on the reader pad. § DO NOT use any liquid cleaning solutions on the 3M RFID Reader. Requesting service Before you call Before you call 3M Service, have the following information available: § Have the reader pad connected with power applied and near the telephone.
