User's Manual
Table Of Contents
- Safety Information
- Intended use
- Explanation of signal word consequences
- Explanation of product safety label symbols
- Warnings
- Cautions
- Japan
- Label locations (Model 942 and 943)
- Label locations (Model 946)
- EMC compliance USA and Canada
- Introduction
- Using the Model 942
- Using the Model 943 and Model 946
- Troubleshooting
- Service telephone numbers
17
Using the Model 943 and Model 946
Software interface overview
Operation and Settings Menus
See
Staff menus (following) for
more information.
Check-in and Checkout buttons
Buttons that allow easy selection of
the two main operating modes.
Item Information
Item ID, information.
O
peration Menu
Settings Menu
Check-in Button
Checkout Button
Item
Information
940_UG_010
Staff menus
Operation Menu
Enables selection of operating mode
and provides method for exiting
application.
Staff Settings
Enables changes to staff settings,
which are in effect until changed
again or until the application is
restarted.
Exit Application
Operation
Mode
S
ta
ff
S
ettings
940_UG_011
Hot keys
Hot keys are individual keys or key sequences set up by the administrator to
enable staff to select check-in, checkout and send ID modes from the
keyboard. See your administrator for information on hot key setup.
Target application
A target application is the application that will receive input from the Staff
Workstation. Typically, this is the circulation system. See
Selecting a target
application
on page 18 for information on how to select a target application.