User's Manual
Table Of Contents
- Safety Information
- Intended use
- Explanation of signal word consequences
- Explanation of product safety label symbols
- Warnings
- Cautions
- Japan
- Label locations (Model 942 and 943)
- Label locations (Model 946)
- EMC compliance USA and Canada
- Introduction
- Using the Model 942
- Using the Model 943 and Model 946
- Troubleshooting
- Service telephone numbers
18
Processing items
Setting up communication with the circulation system
Many Staff Workstation operations require communication with the library’s
circulation system. To enable this communication, you need to do the
following:
1 Start the circulation system software.
2 Start the Staff Workstation software and then select the circulation
system as the “target application.”
When you select a target, you can make the application the permanent
target, or you can choose to select a target each time you initiate an
operation that requires communication with the circulation system.
Selecting a target application
1 Make sure that the target application, which is usually the
circulation system, is running.
Press Ctrl + Alt + T before you begin processing items.
2 At the prompt, do the following:
a Select the target from the application list.
b Check Always send IDs to the selected application, if you
want this to be the permanent target.
c Click OK.
Circulation System
target_app