User's Manual
Table Of Contents
- Safety Information
- Intended use
- Explanation of signal word consequences
- Explanation of product safety label symbols
- Warnings
- Cautions
- Japan
- Label locations (Model 942 and 943)
- Label locations (Model 946)
- EMC compliance USA and Canada
- Introduction
- Using the Model 942
- Using the Model 943 and Model 946
- Troubleshooting
- Service telephone numbers
21
Sending item IDs to the circulation system
Use this topic to send an item ID to the circulation system without sensitizing
or desensitizing the security strip, which is required when processing
magnetic media.
1 Choose send ID using any of the following methods:
Hotkeys (See the administrator if you need to
know which keys have been configured as
hotkeys.)
Send ID entry on the the Operation menu
Magnetic media button on the Book Check unit
940_UG_016
2 Confirm that the unit is in magnetic media mode by
ensuring that the Magnetic Media mode light is lit.
Lit in Magnetic
Media Mode
940_UG_017
3 If this is a checkout operation, do the following:
a Place the patron’s library card over the Book
Check sensor and under the scan line.
b At the prompt, remove the library card.
940_UG_014
Patron
Card