User's Manual

3 -Installing a MiY Device  16
Proprietary
3.5 Panel-in Wiring
The Panel in wiring can be done by placing the wire into terminal block slot (B4) LED – like Panel
Input (0) as well as connecting a ground cable from the panel to either terminal block slot (A4)
Power GND or (C4) Wiegand Input GND. If your device is connected via Wiegand to an access
control panel, then you can connect a wire from (C3) Wiegand Output GND to (C4) Wiegand
Input GND.
The administrator will also need to enable the Panel-in check under General settings in the
Device Info admin menu.
This can also be done in the MiY-Security Manager under the system settings dialog. Refer to
the MiY Security Manager User Guide for instructions.
3.6 Relay & Line Trigger Wiring
Relay and Line Trigger wiring can be done by placing the wire into the correct terminal block
and turning the tightening screw to ensure the wire will stay in place.