Manualshelf

User's Manual

ManualsBrands3M ManualsElectronicsMiY-Card
31323334353637383940
6 -Upload Package via USB 33
Proprietary
6 Upload Package via USB
NOTE: The Device Admin Utility can always export data from a device, but can only send data
to a device when the device is in standalone mode.
MiY devices are shipped in Standalone mode (no MiY-Server or MiY-Security Manager required)
and remain in standalone mode until registered to a server. Once registered to a server, the
device is considered to be in managed mode because it is controlled by the server. To return
the device back to standalone mode, the device must be unregistered from the server either
from the device menu (Reset Sitekey) or from the MiY-Security Manger (Remove device).
All device data (users, operators, prints, logs, packages, etc.) can be imported and exported to
and from the device via the OTG USB port with the MiY Device Admin Utility. The Device Admin
Utility is used to deploy packages (Firmware, Nurse and GateApp) to the device while in
standalone mode.
In order to use the OTG USB port, it must be enabled. To enable the OTG USB port, refer to the
section Enabling the OTG USB Port.
6.1 Deploying a Package
To deploy a package using the Device Admin Utility:
1 Install and run the MiY Device Admin Utility application on your PC or laptop.
2 Set the OTG USB port on the MiY device to Normal mode. Refer to the subsection Enabling
the OTG USB Port for details.
3 Connect the OTG USB port on the bottom of the device to your PC or laptop with a USB
cable. We recommend that you use a USB cable with a ferrite bead embedded into the cable.
The device will be displayed in the PACS Device Manager as a “MiY Device”.
NOTE: The MiY Device Driver should be installed by the Device Admin Utility installer.
However, if the driver is not installed, the device will be displayed with an exclamation
point. Perform a manual installation of the MiY Device Driver via the PC’s Device Manager,
Add New Device wizard, or other preferred method. From here, you can point to the MiY
Device Driver files to install the driver for the unknown device