User's Manual

DT-018581 Reader User Guide

Unpacking the Reader

Each reader package consists of:

• 1 reader

• 1 power supply converter

• 1 AC cable

• 1 test card

• 1 Documentation/Software CD

• 1 USB communication cable

• 1 Scotch-Brite™ Microfiber Cleaning Cloth

1. Remove the contents from the box and separate the components from the packing

material.

2. Verify that all the parts described have been received. If any parts are missing, contact

3M Global Technical Services (GTS).

For more information, see Appendix D: Customer Service on page 27.

3. Store the packaging in the event that the reader may require reshipment to 3M for

maintenance.

Note: Allow the reader to come to room temperature for a minimum two hours

before operation, if it has been stored below room temperature.

Installing the Software

The installation CD contains several components necessary to properly install the Reader.

Note: Do not attempt to install the application without the required operating system and

service packs prior to installation.

The package installs:

• 3M™ Authentication Software and SDK

• USB Driver

• Smart Card Reader Driver (3M™ ePassport Reader only)

• Contactless Reader Driver (3M™ ePassport Reader only)

• Additional SDKs based on the reader model

Note: You must have PC Administrative rights to install the software.

1. Insert the CD supplied with the unit into the CD drive.

Note: If "Autorun" is enabled, installer.exe will run automatically. If "Autorun" is

not enabled, follow the steps below:

2. Run the Setup.exe application from the CD.

The InstallShield® Wizard window opens to install the 3M™ Document Authenticator.