User manual

13
2012 March
800rf-NA
4-SPECIFICATIONS (continued)
4.6 Tape Roll Diameter
Up to 410mm [16 inch] maximum on a 76.2mm [3 inch] diameter core.
(Accommodates all system roll lengths of Scotch
®
fi lm tapes.)
4.7 Tape Application Leg Length – Standard
70mm ± 6mm [2 3/4 inch ±1/4 inch]
Tape Application Leg Length – Optional
50mm ± 6mm [2 inch ±. 1/4 inch]
(See "Removing Taping Heads Procedure – Changing the Tape Leg Length")
4.8 Box Board
Style – regular slotted containers – RSC
125 to 275 P.S.I. bursting test, single wall or double wall B or C fl ute.
23-44 lbs. per inch of width Edge Crush Test (ECT)
4.9 Box Weight and Size Capacities
A. Box Weight, fi lled: 65 lbs. [2 kg–30 kg] ,maximum. Minimum must be suffi cient to hold case on the
conveyor bed with bottom fl aps fl at.
B. Box Size: Minimum Maximum
Length – 200mm [8.0 inch] 600mm [23.5 inch]
Width – 160mm [6.3 inch]* 500mm [20 inch]
Height – 140mm [5.5 inch] 500mm [20 inch]
(See "Special Set-Up Procedures".)
Note: The case sealer can accommodate most boxes within the size range listed above. However, if the box
length (in direction of seal) to box height ratio is 0.6 or less, test run several boxes to ensure proper
machine performance.
DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:
BOX LENGTH IN DIRECTION OF SEAL = SHOULD BE GREATER THAN 0.6
BOX HEIGHT
Any box ratio approaching this limitation should be test run to ensure performance.