User manual

9-OPERATION
25
When the 4th photocell is obscured, the side drive
belts stop. The gate between the rollers, positions
the box correctly
(Figure 9-4).
The upper group then comes down on the box after
folded the front fl ap, the height pick-up device stops
the upper group descent (Figure 9-5).
2012 March800rf-NA
9.1 Operation
- Give air to the machine by the ON/OFF valve, set
the main switch to ON (I) position;
- Close the safety guards; release the E-stops;
- Press AUXILIARIES button,
- Press RESET button; press START button.
The box, after passed the infeed conveyor belt,
obscures the fi rst photocell (Figure 9-1)
When the second photocell is obscured the infeed
conveyor belt goes down in order to stop the next
box. The side guides A align the box.
The next box obscuring the fi rst photocell cause the
infeed conveyor belt stoppage (Figure 9-2).
The side guides open and the box obscures the third
photocell. The side drive belts B go against the box
and, if the box is longer than 500mm, the rear fl ap
folder is controlled (Figure 9-3).
Figure 9-1
Figure 9-2
Figure 9-3
Figure 9-4
Figure 9-5
B
A