User's Manual

ManualsBrands3M ManualsElectronicsRFID Reader Pad

Table Of Contents

MiniRFIDPadModel210

Owner’sManual

Summary of content (16 pages)

PAGE 1
Mini RFID Pad Model 210 Owner’s Manual
PAGE 3
Contents Safety ............................................................................................................................................. 1 EMC compliance............................................................................................................................. 3 Overview......................................................................................................................................... Model 210 components............................................
PAGE 5
Safety Intended use The 3M Mini RFID Pad Model 210 is designed and tested for use with other equipment and software to read and/or program 3M RFID tags. These tags are used to identify files, folders, and other items such as books. When used in conjunction with software, the unit can track, monitor, and assist in locating various items equipped with RFID tags. The product has not been evaluated for other uses.
PAGE 6
Safety Label location Model 210 5V This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This Class A digital apparatus Canadian ICES-003. FCC ID: DGFTTS210 IC: 458A-TTS210 500mA S/N: 210XXXXX I.T.E. LISTED 4P24 N1108 3M Track and Trace Solutions St.
PAGE 7
EMC compliance FCC Intentional Radiator Certification Mini RFID Pad Model 210 FCC ID:DGFTTS210. This equipment contains an intentional radiator approved by the FCC under the FCC ID numbers shown above. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation.
PAGE 9
Overview The Mini RFID Pad Model 210 is used with other equipment and software to read and/or program RFID tags. These tags are used to identify files, folders, and other items such as books. When used in conjunction with pad software, the unit can track, monitor, and assist in locating various items equipped with RFID tags.
PAGE 11
Install the Model 210 Determine the best placement for the pad • Place the pad on a flat, non-metallic surface in a convenient location. For best performance, make sure that the pad is at least 2 in. (5 cm) away from any metal surface, keeping in mind that some desks and tables may have metal parts underneath the surface. If necessary, the pad can be as close as 1.0 in. (2.5 cm) to a metal surface. This will reduce the read range. GR_210_dimensions 7.21 in 18.
PAGE 12
Install the Model 210 Connect the hardware Use the illustration to connect the hardware. Customer-supplied Computer USB Cable 210 cabling 8 Mini RFID Pad Copyright © 2008. 3M. All rights reserved.
PAGE 13
Troubleshooting Introduction to the LEDs on the bottom of the unit The following is a brief introduction to the LEDs that are located on the bottom of the unit, which will aid in troubleshooting. 1. Solid green when the unit is powered on. 2. Blinking red when communicating with software. 3. Blinking green when the firmware is working and the unit is waiting for a command.