User's Manual

Octopus ATM Defense System
Installation and Operation Guide
Page 10 of 25
Installation Instructions:
First the CSUs should be installed into the ATM cassettes, then the MCU can be installed.
Installation of the CSU depends on the manufacturer make and model of the cassette. The instructions for
modification of the supported cassettes are attached in Appendix E through I. Please refer to the table of contents
in order to determine the make and model of the cassette you wish to install.
Insure that all external sensors and switches (DOOR, SMOKE, BREACH, SIREN, etc.) are installed prior to
configuring the MCU. Appendix B contains instruction for these items.
CSU Installation
Upon receipt of the CSU ink delivery system, the vacuum form cover should be removed for initialization and
installation.
1. Verify and install jumpers using Appendix D as required.
The Power jumper (J4), Disable Squib jumper (J3), and either the ink delivery assembly or a squib jumper
attached inside the squib wire connector should be installed.
2. Press the POST button with the unit in the correct orientation for installation into the cassette.
If the self test is good (1 long beep) disconnect the ink delivery system and continue installation.
If there is a fault or error reported use Appendix A to isolate and correct problem.
Squib wires must be shorted or ink block connected for the unit to pass self-test.
3. Follow the bracket installation guides in Appendix E though I depending on the make and manufacturer of the
cassette.
• Appendix E -Installation Instruction Diebold MMD
• Appendix F -Installation Instruction DeLaRue MDDM
• Appendix G -Installation Instruction Perto “A” C-130
• Appendix H -Installation Instruction DeLaRue NMD
• Appendix I -Installation Instruction NCR
4. Once the bracket is installed correctly, re-attach the squib connection from the PCB to the ink delivery unit.
5. Press the POST button with the cassette in the correct orientation.
If the self test is good (1 long beep) the installation is complete.
If there is a fault or error reported use Appendix A to isolate and correct problem.
6. Remove ink block from Squib connection and place jumper across CSU wires to safe the system for testing.
CSU INSTALLATION COMPLETE
Test mode may be used to verify unit functionality see Appendix T for instruction.