User's Manual

Octopus ATM Defense System
Installation and Operation Guide
Page 12 of 25
Note
12. Connect all used sensor array wires to the ATM sensor array (or provided sensors). Refer to Appendix C for a
wire color chart of provided cabling.
13. Any unused sensor inputs should be shorted to the ground wire if the are normally closed. If the sensor input
is normally open, caution should be used to insure that they do not make accidental contact to ground.
14. If Test Mode is to be initiated hold down the POST button will re-installing the power jumper J4.
15. If Test Mode is selected got Appendix T for instructions. Else continue below.
16. Fasten case together securely using the 4 screws provided. Insure that no wires or electronic components are
strained or trapped.
17. Using the provided alcohol wipes, insure that the mounting surface is free of debris and oily residue.
18. Remove the protective coating from the velcro strips while they are still attached to the MCU.
19. Place the MCU into place pressing firmly to allow the tape to adhere to the ATM.
20. The cassettes should be installed into the ATM rack.
21. Actuate the MCU’s POST button.
22. Self-test will commence. The first indication will be the flashing of the green LED while the CSU counts the
number of CSUs it found.
23. If all CSUs are reported, then the area of install is acceptable.
24. The second indication will be the self test.
If the self test is good (green led flashed , 1 long beep) proceed to step 26.
If there is a fault or error reported use Appendix A to isolate and correct problem.
Not correcting the fault or error condition may reduce the protection capability of the system.
25. Once all errors and or faults are cleared
26. Clean-up any excess wiring and use cable ties, cable stays, or saddle wires to secure any loose wiring.
27. Close ATM door, listen for CSU beeps, MCU count, and fault indication.
28. If a fault exists go to step 24 repeat until all errors are resolved.
MCU INSTALLATION COMPLETE
29. Remove cassettes, open them, re-attach the ink blocks.
30. Install the cassettes into ATM, replenish as required.
SYSTEM INSTALLATION COMPLETE