User's Manual

12.0 Secure Bracket Assembly
Reinsert the Bracket assembly, install the three mounting screws with fiber
washers. Do not tighten.
Reset the distance between the front of the bracket and the inside of the
cassette front to 42mm Figure 5 and tighten the three mounting screws.
Open and close the cassette cover to check for interference. Adjust as
required.
13.0 Test Electronics
Test the CSU electronics by depressing and releasing SW9 (Figure 7). One
beep indicates that the CSU is fully functional. Two beeps indicates a failure
and requires troubleshooting. Recheck cable connections and shunt
connections (Section 11.0). This completes the installation
Page E7Octopus ATM Defense System
Installation and Operation Guide